This preventive maintenance schedule describes basic maintenance
for your Rosback finishing equipment that will help keep it in good continuous
operating condition. The recommendations in this schedule is based
on average use and operating conditions. Alter this schedule as required by the
conditions in your facility.
|
Preventative Maintenance & Lube
Schedule |
| Schedule |
Description |
Action |
| Daily |
Keep metal surfaces clean, free from dust, and
rust. |
A light coat of SAE 10 oil may be added to the
metal surfaces that do not come in contact with the paper stock. It is a
good idea to cover the perforator when it is not in use to keep dust from
settling in working parts. |
| Weekly |
Check condition of sucker cups and crown
retainers at each pocket. |
Replace damaged, cracked, or hardened cups.
Replace bent or deformed crown retainers. |
| Weekly |
Verify air flow from each air blast nozzle at
each pocket. |
If air flow is poor or not flowing, use a fine
gauge wire to clean air blast nozzle. |
| Monthly |
Clean and lubricate primary and secondary
chains. |
Clean chains with a light coat of SAE 30 oil. |
| Monthly (724 only) |
Clean and lubricate primary and secondary
chains. |
Clean chains with a stiff nylon brush to remove
dirt and paper dust. Re-lubricate using SPRAYON LUBRICANTS #S00708 T.F.E.
DRY LUBE or similar, plastic safe, T.F.E. dry lubricant. |
| Monthly (724 only) |
Lubricate suction bar pivot shaft bushings
(16
locations) |
Apply a drop or two of SAE-30W oil to the
bushings supporting these shafts. |
| Monthly (724 only) |
Lubricate serpentine belt tensioners under
lower RH. guard (2 locations). |
Use a grease gun to apply NLGI grade 2 grease
directly into grease fitting |
| Monthly (724 only) |
Lubricate stub shaft housings under lower RH.
guard (1 location) and behind the rear lower cover (2 locations). |
Use a grease gun to apply NLGI grade 2 grease
directly into grease fitting |
| Monthly (724 only) |
Lubricate mounted bearings behind the rear
lower cover (2 locations). |
Use a grease gun to apply NLGI grade 2 grease
directly into grease fitting |
| Quarterly |
Inspect vacuum pump filters. |
Clean or replace all vacuum pump filters. |
